Biostar H61MGC Setup Manual - Page 11

Memory Capacity, Dual Channel Memory Installation

Get Biostar H61MGC PDF manuals and user guides View all Biostar H61MGC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

H61MGC / H61MLC 2. Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated. Note: If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again. B. Memory Capacity DIMM Socket Location DDR3_A1 DDR3_B1 DDR3 Module 512MB/1GB/2GB/4GB/8GB 512MB/1GB/2GB/4GB/8GB Total Memory Size Max is 16GB. C. Dual Channel Memory Installation Please refer to the following requirements to activate Dual Channel function: Install memory module of the same density in pairs, shown in the table. Dual Channel Status DDR3_A1 DDR3_B1 Disabled O X Disabled X O Enabled O O (O means memory installed; X, not installed.) The DRAM bus width of the memory module must be the same(x8 or x16) 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
H61MGC / H61MLC
9
2.
Insert the DIMM vertically and firmly into the slot until the retaining
chip snap back in place and the DIMM is properly seated.
Note:
If the DIMM does not go in smoothly, do not force it. Pull it all the way out
and try again.
B.
Memory Capacity
DIMM Socket
Location
DDR3 Module
Total Memory
Size
DDR3_A1
512MB/1GB/2GB/4GB/8GB
DDR3_B1
512MB/1GB/2GB/4GB/8GB
Max is 16GB.
C.
Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status DDR3_A1 DDR3_B1
Disabled
O
X
Disabled
X
O
Enabled
O
O
(O means memory installed; X, not installed.)
The DRAM bus width of the memory module must be the same(x8 or
x16)