Biostar P4TAW EXTREME P4TAW Extreme user's manual - Page 11
Memory Module Installation
 |
View all Biostar P4TAW EXTREME manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
P4TAW Extreme 2.2 MEMORY MODULE INSTALLATION 1. Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot. 2. Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated. Note: To assure the system safety, if you need to change DDR2 modules, firstly, please unplug the 12-pin power cable with the power connector, and then you can change the modules. Afterwards, plug in the cable the power connector again, and finally you can boot up the system. 11
-
1 -
2
-
3
-
4
-
5
-
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
 |
 |
P
4
T
A
W
E
x
t
r
e
m
e
11
2.2
M
EMORY
M
ODULE
I
NSTALLATION
1.
Unlock a DIMM slot by pressing the retaining clips outward. Align a
DIMM on the slot such that the notch on the DIMM matches the
break on the Slot.
2.
Insert the DIMM vertically and firmly into the slot until the retaining
chip snap back in place and the DIMM is properly seated.
Note:
To assure the system safety, if you need to change DDR2 modules,
firstly, please unplug the 12-pin power cable with the power
connector, and then you can change the modules. Afterwards,
plug in the cable the power connector again, and finally you can
boot up the system.