Biostar T5 XE Setup Manual - Page 3
Introduction - sli
View all Biostar T5 XE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
CHAPTER 1: INTRODUCTION T5 XE/T5XE CFX-SLI 1.1 BEFORE YOU START Thank you for choosing our product. Before you start installing the motherboard, please make sure you follow the instructions below: Prepare a dry and stable working environment with sufficient lighting. Always disconnect the computer from power outlet before operation. Before you take the motherboard out from anti-static bag, ground yourself properly by touching any safely grounded appliance, or use grounded wrist strap to remove the static charge. Avoid touching the components on motherboard or the rear side of the board unless necessary. Hold the board on the edge, do not try to bend or flex the board. Do not leave any unfastened small parts inside the case after installation. Loose parts will cause short circuits which may damage the equipment. Keep the computer from dangerous area, such as heat source, humid air and water. The operating temperatures of the computer should be 0 to 45 degrees Celsius. 1.2 PACKAGE CHECKLIST HDD Cable X 1 (optional) Serial ATA Cable X 3 Rear I/O Panel for ATX Case X 1 User's Manual X 1 Fully Setup Driver CD X 1 FDD Cable X 1 (optional) USB 2.0 Cable X1 (optional) Serial ATA Power Cable X 1 (optional) SLI / CrossfireX bridge (T5XE CFX-SLI only) Note: The package contents may be different due to area or your motherboard version. 1