Bissell AeroSwift™ Compact Vacuum 1009 User's Guide - Page 12
Replace drive belt, Check and clean filter
View all Bissell AeroSwift™ Compact Vacuum 1009 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Maintenance & Care Replace drive belt 1. Unplug the vacuum from electrical outlet. 2. With rotating brush removed (follow steps from check rotating brush section), grasp old drive belt and remove from motor pulley. If difficult to remove from pulley, use scissors to cut and remove belt. 3. Place the new drive belt over motor pulley and loop other end over rotating floor brush in the space between bristles. NOTE: The space between the motor pulley and the foot covering is tight. Slide the thin side of the belt down between the motor pulley and foot covering and work with your fingers to position under the motor pulley. 4. With drive belt connected to motor pulley, pull the belt over the brush roll and position the floor brush into the brush cover ends. Rotate the brush end opposite of the belt to line up with the brush cover tab. The brush end closest to the belt will slide in the tab without needing to rotate. 5. Replace brush cover and secure with the 3 screws. Check and clean filter The vacuum comes with a standard foam filter (yellow) located in the filter tray. A Febreze® foam filter (black) is packed into the box in a protective plastic bag. Replace the standard filter with the Febreze® foam filter to eliminate odors and freshen as you vacuum. 1. Unplug the vacuum from electrical outlet. 2. The foam filter is located in the slide out filter tray underneath the dirt bin. It is recommended to check the filter regularly and remove any dirt or debris build up in the tray after or before use. 3. Both the standard yellow foam filter and the Febreze® (black) foam filter are washable. Hand wash in cold water with mild detergent. Rinse well and air dry thoroughly before replacing. NOTICE: Overtime with use and washing, you will begin to notice a loss of scent strength as you vacuum with the Febreze® filter. Even with loss in scent, if there is no wear to the foam, the filter will continue to work effectively by protecting the motor from dirt particles. Contact BISSELL Consumer Care to order replacement filters. WARNING To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks. 3. 4. WARNING Do not operate cleaner with damp or wet filters or without vacuum bags and all filters in place. 3. www.bissell.com 12 800.237.7691