Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 Quick Start Guide - Page 2

QUICK START GUIDE For further instructions reference the User Guide or visit www.BISSELL.com Getting the Best Clean from Your CrossWave® Cordless For everyday Cleaning: HARD FLOORS & RUGS Choose the setting that matches the floor type you will be cleaning. Prime the system by holding the solution spray trigger for 10 seconds. Then, hold the trigger on both the forward and backward pass for great cleaning results. HARD FLOOR 10 Seconds Dirty Machine? EASY CLEANUP For the best results, flush the unit by using the 3-in-1 Docking Station and holding down the Clean Out Cycle button on the carry handle. Then, rinse the Dirty Water Tank, Strainer, Brush Roll, and Brush Chamber. Allow your machine and components to dry completely, then reassemble, making sure the machine's brush window is secure for next use. 1 Clean Up 2 Dry 3 Reassemble 15s RUG Tips & Tricks »»On hard floors, there is no need to vacuum before using CrossWave Cordless. This machine vacuums and washes at the same time. »»Be sure to charge your machine fully before using for the first time. »»To dry floors faster, release the trigger and run the machine over the floor without dispensing solution. »»When cleaning area rugs, remove any excessive mud from your area rug prior to using your CrossWave Cordless. »»When cleaning excessively dirty or muddy hard floors, or if the Brush Roll looks dirty, use the 3-in-1 Docking Station to rinse the Brush Roll before cleaning your area rugs. »»For overly challenging and stuck-on messes on hard floors, activate the RUG mode and hold your CrossWave Cordless over the mess. Using short passes while holding the trigger allows the multi-surface brush to go to work.