Bissell Flip-t Hard Floor Cleaner User Guide - English - Page 8
Dry Vacuuming, Wet Cleaning/Vacuuming, Flipping From Dry to Wet Cleaning
View all Bissell Flip-t Hard Floor Cleaner manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Dry Vacuuming With the Dry Side of the unit facing forward, turn the unit on and begin cleaning. You will see dry dirt, crumbs and debris being collected in the Dirty Tank. You do not have to empty the dry debris before wet cleaning. Flipping From Dry to Wet Cleaning To change from dry vacuuming to wet cleaning simply flip the unit around! The Gentle Clean™ Brush or Pad and Squeegee will automatically be lowered to effectively clean and Dry all your Hard Floor Surfaces. Wet Cleaning/Vacuuming To begin Wet Cleaning, simply pull the Spray Trigger. Water and Formula will be dispensed through the Gentle Clean™ Brush or Pad. On Flip-it Select Models, for heated cleaning press the switch down to turn on the Built-In Heater. Dry Vacuum and Wet Cleaning Off Wet Cleaning using Built-In Heater To maximize the area to be cleaned, it is recommended that the Spray Trigger is squeezed on the forward stroke and released on the reverse stroke. This will dispense water and formula going forward and on the pull back, the squeegee will leave the floor essentially dry and ready to walk on. 8 www.bissell.com Tip: To extend the life of your filter and to maintain maximum dry suction, check the filter for lint and debris frequently Tip: To make sure water and formula are flowing, squeeze the Spray Trigger without the Gentle Clean™ Brush or Pad Inserted. You should see a light stream of water and formula dispensed unto the floor. CAUTION: Do not over wet the floor. Apply solution by depressing the trigger on the forward stroke only and release the trigger on the rearward stroke. Over wetting the floor surface may cause delamination of certain laminated flooring materials. 800.237.7691 ug603-6704_5200_306.indd 8 3/1/06 11:29:03 AM