Bissell PowerFresh Slim Steam Mop 2075 User Guide - Page 14
Troubleshooting
View all Bissell PowerFresh Slim Steam Mop 2075 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Troubleshooting WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. Problem Reduced steam OR no steam Streaking Leaking Knocking Noise Possible causes Water tank empty. Steam level not selected. Wand not installed properly. Foot not installed properly. PAUSE button is pressed. Dirty mop pad. Use on waxed or oiled floor. Mop pad is too wet. Steam level is too high. Crack in unit or water tank. First use or water tank is empty. Metal tube cannot reach water. Remedies Refill tank. Select steam level by pushing steam level button. Push the wand all the way into the handheld pod until you hear a click. Insert the Extension Wand into foot until you hear a click. Once STEAM READY light is solid, select desired steam level (HI or LO) then push the trigger under the handle of the Handheld Pod to release steam. Remove and wash pad per instructions before further use. If you have used floor polishes or wax on your floors, steam products may decrease glossiness. Refer to the wax or polish manufacturer. If you don't wax or polish your floors, check the floor care instructions from your flooring manufacturer. Remove and replace with dry mop pad and intermittently press the steam trigger for less steam. Lower the steam level. Check to see if there are any cracks on the unit or tank and check to make sure the rubber gasket on the tank is still attached and seated properly in the unit. Fill water tank and knocking will diminish after a few seconds. Shake the pod to let the tube reach the water level. 14 www.BISSELL.com