Bissell Powerglide Upright Cordless Vacuum 1534 User Guide - Page 8

Maintenance & Care Cleaning the dirt container 1. Release dirt tank as above, then twist the top right to separate. 1. 2. 2. Remove filter by pulling up on the fabric tab, then pull out the cyclone system. 3. Rinse and dry dirt container with a paper towel. 4. To reassemble, line cyclone system up with dirt container using the semi circular and square tabs then slide in. Place filter on top with fabric tab on the upper face, place lid last and twist left. 3. 4. Cleaning the filter and cyclone 1. Release tank and remove lid as above, then remove Pre-motor Filter, clean with mild detergent and rinse. 2. Reinsert inside Dirt Container, once completely dried. 3. Remove cyclone system from dirt container as above. 4. The cyclone system can be broken down into three parts for easy cleaning. All pieces come apart with a simple twist. Rinse and dry with a paper towel. Tip » To maintain suction and good performance, it is recommended that you clean your filters every 4-5 uses and clean your cyclone system every other time you clean the filter. WARNING Do not operate cleaner with damp or wet filters or without vacuum bags and all filters in place. 1. 2. 3. 4. Replacing the Brush 1. Turn power switch off, turn over and use a wcoin or a flathead screwdriver to open the 2 1. 2. locking screws on either side of the brush bar. 2. Remove both brush plates to access brush bar. 3. Grasp the roller from the bottom, dislodge by pulling, and then thread it through the belt. 4. Replace roller and reverse the order to reassemble. 3. 4. www.BISSELL.com 8