Bissell Powergroom Pet Canister Vacuum Powergroom Pet Canister User's Guide - Page 10

Dust bag replacement

Page 10 highlights

Operations Dust bag replacement 1. Unplug the vacuum from electrical outlet. 2. Disconnect hose 3. Open the dust bag compartment by lifting up on the latch on the door on the front of the vacuum. 4. Lift out the dust bag holder and dust bag. 5. Release the dust bag from the holder by pressing the dust bag holder clip and pulling the dust bag out of the holder. Discard the used dust bag. 6. Slide the new dust bag into the holder by inserting the dust bag into the tabs located at the bottom of the holder. Then press the dust bag holder clip, insert the dust bag and release the dust bag holder clip to hold the dust bag in place. 7. Place holder and new dust bag back into the dust bag compartment, making sure the entire bag is tucked in below the seal gasket. 8. Close dust bag compartment door and press down gently until it locks into place. NOTE: The dust bag compartment door will not close without the dust bag in place. 9. Reconnect hose. 3. 4. 5 WARNING: To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. 10 www.bissell.com 800.237.7691

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

www.bissell.com
800.237.7691
O
perations
10
Dust bag replacement
1.
Unplug the vacuum from electrical outlet.
2.
Disconnect hose
3.
Open the dust bag compartment by
lifting up on the latch on the door on
the front of the vacuum.
4.
Lift out the dust bag holder and dust bag.
5.
Release the dust bag from the holder
by pressing the dust bag holder clip
and pulling the dust bag out of the
holder. Discard the used dust bag.
6.
Slide the new dust bag into the
holder by inserting the dust bag into
the tabs located at the bottom of
the holder.
Then press the dust bag
holder clip, insert the dust bag and
release the dust bag holder clip to
hold the dust bag in place.
7.
Place holder and new dust bag
back into the dust bag compartment,
making sure the entire bag is tucked
in below the seal gasket.
8.
Close dust bag compartment door
and press down gently until it locks
into place.
NOTE: The dust bag compart-
ment door will not close with-
out the dust bag in place.
9.
Reconnect hose.
3.
4.
5
WARNING:
To reduce the risk of electric
shock, turn power switch OFF
and disconnect plug from
electrical outlet before
performing maintenance or
troubleshooting checks.