Bissell PurePro Multi Cyclonic Vacuum User Guide - Page 7
Caution
View all Bissell PurePro Multi Cyclonic Vacuum manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Cleaning carpet, rugs or bare floors Handle Release Pedal Press the Handle Release Pedal with your foot to change your Lift-Off from full upright/above floor cleaning position to normal carpet cleaning position, or for low cleaning under beds and low furniture. Always store or transport in the full upright position, rolling the cleaner on rear wheels only. Cleaning with the Detachable Canister The Detachable Canister feature makes it possible to take the powerful cleaning action of your BISSELL Lift-Off to stairways, auto interiors, or other hard-to-reach areas of your home. Before detaching the Canister, your Lift-Off must be in its fully upright position. You do not need to turn off the power first. 1. Press the Lift-Off Release Latch at the back of the Chassis and lift the Canister to remove. 2. Detach the Vacuum Hose from the port at the back of the PowerFoot. 3. Press fit the desired tool to the end of the Vacuum Hose. 4. When you're done, return the Canister to the Powerfoot/Chassis by sliding it straight down the Chassis over the power port and remove the tool used. The Lift-Off Latch will lock the Canister in place. Reconnect the Hose to the vacuum port. CAUTION: Always place vacuum cleaner on floor in its fully upright position, and make sure it is locked into place before removing Canister or when using tools. Placing the Lift-Off in its full upright position automatically stops the rotating brush, and the headlight will turn off. Tip: Before cleaning under low furniture, check for objects that might harm the rotating floor brush or block the vacuum hose. Do not pick up hard or sharp objects such as glass, nails, screws, coins, paper clips, etc. Powercord Storage When you are done cleaning, return your Lift-Off to the Upright position and store the Power Cord. 1. Turn vacuum cleaner OFF. 2. Unplug Power Cord by grasping the polarized plug (NOT the cord) and disconnect from outlet. 3. Loop Power Cord around Cord Wraps on the side of Canister. 4. Clip molded plug to Power Cord to secure. 7