Bissell Steam & Sweep Hard Floor Cleaner User's Guide - Page 7

Operations Getting ready 1. The mop pad may have already come attached to the swivel head. If not, attach mop pad to swivel head using the Velcro strips. 2. Fill the water tank. A. Remove the tank by lifting straight up and away from the unit. B. Unscrew the cap at the bottom of the water tank and remove the insert 2B. assembly. C. Fill the water tank with water. For best results, water should be at room temperature. D. Replace the insert assembly and cap, tighten until snug. E. Replace the water tank by lining up the vertical guides and gently sliding it back into place. 3. Twist the quick release cord wrap clockwise to unwrap the power cord completely, make sure both switches are in the "OFF" position and plug it into a 120-volt grounded outlet as described on the Important Safety Instructions page. 4. Turn power button on. The ready light will illuminate when the Steam & Sweep is ready for use. NOTE: Upon first use of the Steam & Sweep or first use of a new filter, the pump may make a "knocking" sound while the filter fills with water. This is normal and should not last longer than 30 seconds. Continue to depress the trigger until the knocking subsides. 2A. 2D. 2E. WARNING: Steam & Sweep will not pick up crayons, marbles, and other large objects. w w w. b i s s e l l . c o m 7 800.237.7691