Bissell Zing® Bagged Canister Vacuum User Guide - Page 9

Troubleshooting Vacuum cleaner won't run Possible causes WARNING: To reduce the risk of electric shock, turn power OFF ( ) and disconnect plug from electrical outlet before performing maintenance or troubleshooting. Remedies 1. Vacuum cleaner is not plugged in 2. Power button is not pressed down 3. Thermal protector activated 1. Check electrical plug 2. Press power button down 3. Allow cleaner to cool for 30 minutes, see page 8 Vacuum cleaner won't pick up or low suction Possible causes Remedies 1. Tools, hose and/or telescoping extension wands are blocked 2. Filters are dirty 3. Dust bag is full 4. Swivel hose not securely attached to suction opening 5. Crack or hole in flex hose 6. Air flow regulator or variable suction power control is set to open or minimum setting 1. Remove each part and check for blockages 2. Check and clean or replace pre-motor and post-motor filters 3. Replace with new dust bag 4. Make sure hose connector is locked into suction opening 5. Check hose and replace if needed 6. Change to closed or maximum setting Visible dust escaping from vacuum Possible causes Remedies 1. Dust bag is full 2. Filters missing or installed incorrectly 3. Filters are dirty 4. Flex hose is blocked 5. Swivel hose not securely attached to suction opening 6. Crack or hole in flex hose 1. Replace with new dust bag 2. Check pre-motor and post-motor filter for correct installation 3. Check and clean or replace pre-motor and post-motor filters 4. Remove hose and check for blockages 5. Make sure swivel hose is locked into suction opening 6. Check hose and replace if needed Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store. For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-237-7691. www.bissell.com 9 800.237.7691