Black & Decker ASI500 Type 1 Manual - ASI500 - Page 9

90564808 AS1500.qxd:??????-00 BDL500 laser 5/18/10 9:56 AM Page 9 OPERATING THE LED LIGHT To switch on the LED light (12): • Switch the main power switch (1) to the inflate (c fig. G) or the pump (a fig. G) position. • Press either of the - or + buttons (21, 23) on the LCD (2) to turn the LED light (12) on. To switch the LED light (12) off: • Press either of the - or + buttons (21, 23) again. • Turn the main power (1) switch to off. SLEEP MODE TO PRESERVE BATTERY LIFE • The unit is fitted with a sleep mode function that will help prolong the life of the internal battery. • If the unit is left on and unused for more than 2 minutes the unit will drop into sleep mode. • To power the unit again either switch the main power switch (1) on and off or press any button on the LCD (2). Note: After sleep mode, all settings will be lost and will need to be re-entered following the instructions under the heading 'Setting the automatic shut-off pressure'. REPLACING THE FUSE IN THE VEHICLE DC ACCESSORY PLUG • Remove the cap by turning it counterclockwise. • Remove the center pin. • Remove the fuse. • Fit a new fuse of the same type and size (8A/250V). • Refit the cap and center pin. • Tighten the cap by turning clockwise onto the plug. BATTERY REMOVAL (FOR RECYCLING) (FIGURE I) I WARNING: Exercise care when handling batteries in order not to short the battery with conducting materials such as rings, bracelets and keys. The battery or conductor may overheat and cause burns. Before attempting to disassemble the main body of the product, turn it on and leave it on until the power is depleted to ensure a complete discharge of the battery. Using a phillips screwdriver, remove the screws from the bottom housing cover shown in figure I. Lift the battery out and pull off the terminal clips. See "Service Information" for battery replacement. MAINTENANCE Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts. THE RBRC™ SEAL The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the lead acid battery (or battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. In some areas, it is illegal to place spent lead acid batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally conscious alternative. RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and Canada to facilitate the collection of spent lead acid batteries. Help protect our environment and conserve natural resources by returning the spent lead acid battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery, or call 1-800-8-BATTERY. 9