Black & Decker BDEQS300 Instruction Manual - Page 6

Lock-on / lock-off Slider This sander is equipped with a switch that allows you to lock it on for extended use, and lock off to prevent accidental actuation. Lock On • To lock the tool on, depress the paddle (1) with one hand and push the slider (2) right to the locked position with your other hand as shown in Figure E. • To stop the tool, push the slider left to the unlocked position and release paddle. Lock off • To lock the tool OFF, make sure the paddle (1) is not depressed and push the slider (2) right to the locked position. The paddle cannot be depressed while switch is in locked position. • To unlock the paddle, push the slider left to the unlocked position. The paddle can now be depressed. E place as shown in the insert of Figure F. • To remove, turn the canister counterclockwise and slide the canister off. • To empty the canister, remove it from the dust port and dump the sanding debris into an appropriate trash receptacle. F 10 9 8 Hints for optimum use • Do not place your hands over the ventilation slots. • Do not exert too much pressure on the tool. • Regularly check the condition of the sanding sheet. Replace when necessary. • Always sand with the grain of the wood. • When sanding new layers of paint before applying another layer, use extra fine grit. • On very uneven surfaces, or when removing layers of paint, start with a coarse grit. On other surfaces, start with a medium grit. In both cases, gradually change to a fine grit for a smooth finish. dust COLLECTION WARNING: Collected sanding dust from sanding surface coatings (polyurethane, linseed oil, etc.) can selfignite in sander dust bag or elsewhere and cause fire. To reduce risk, empty bag frequently and strictly follow sander manual and coating manufacturer's instructions. CAUTION: Respiratory hazard. Never operate this tool for wood sanding unless the dust canister is in place. Sanding dust exhaust may create a breathing hazard. WARNING: Fire hazard. When working on metal surfaces, do not use the dust canister because sparks are generated. Wear safety glasses and a dust mask. Due to the danger of fire, do not use your sander to sand magnesium surfaces. Do not use for wet sanding. Your sander comes equipped with a cloth canister (6) to collect the dust generated while sanding. • To attach the canister to the sander, line up the grooves (8) in the canister (6) with the nubs (9) on the dust port (5). Ensure the longer side (10) of the canister opening is on the top side of the port. • Slide the canister onto the dust port and turn the canister clockwise to lock it in Maintenance Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. accessories WARNING: The use of any accessory not recommended for use with this tool could be hazardous. Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986. Service Information All Black+Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black+Decker location nearest you. To find your local service location, call: 1-800-544-6986 or visit www.blackanddecker.com 6