Black & Decker HHVI320JR02 Instruction Manual - Page 5
Cleaning and emptying the, product, Nozzle / Accessories HHVI320JR, and HHVI325JR - replacement filter
View all Black & Decker HHVI320JR02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
For a more thorough cleaning F (figures I & J) • Figure I - Remove the dust bowl by pressing the bowl release button and pulling the bowl straight off. • Remove filter from within the bowl. I Cleaning and emptying the product WARNING: Projectile/ Respiratory Hazard: Never use the vac without its filter. NOTE: The filter is re-usable, do not confuse it with a disposable dust bag, and do not throw it away when the product is emptied. We recommend that you replace the filter every 6-9 months depending on frequency of use. There are two methods of cleaning the bowl, a quick empty method and a thorough clean method. For a quick empty (figures G, H) • Figure G - Press in on both nozzle release buttons on the sides of the nozzle and remove the nozzle by pulling straight off. • Remove the cloth filter and shake or lightly brush any loose dust off both filters. • Figure J - The dust bowl and filter can be washed in warm soapy water. Allow to dry before placing back into the vac. J G • Figure H - Empty the dust from the bowl. • For a more thorough cleaning, remove bowl as described below. H • Place filter back into the bowl pressing firmly to ensure a secure fit. • To replace dust bowl, place it back onto the handle until it "clicks" firmly into position. IMPORTANT: Maximum dust collection will only be obtained with a clean filter and an empty dust bowl. If dust begins to fall back out of the product after it is switched off, this indicates that the bowl is full and requires emptying. • Wash the filters regularly using warm, soapy water and ensure that it is completely dry before using again. The cleaner the filter is, the better the product will perform. • It is very important that the filter is correctly in position before use. Nozzle / Accessories (HHVI320JR and HHVI325JR) • Figure K - A crevice tool is built into the nozzle and can be extended as shown in figure K by pulling the extension piece until it locks into position. 5