Bosch 11536VSR Operating Instructions - Page 10
FIG. 6, FIG. 7, FIG. 8 - hammer drill
![]() |
UPC - 000346354607
View all Bosch 11536VSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
BM 1619929800 12-07 12/4/07 8:32 AM Page 10 INSTALLING & REMOVING ACCESSORIES 3-JAW CHUCK For small bits, open jaws enough to insert the bit up to the flutes. For large bits, insert the bit as far as it will go. Center the bit as you close the jaws by hand. This positions the bit properly, giving maximum contact between the chuck jaws and the bit shank (Fig. 6). To tighten chuck, insert key into each of the three key holes in succession and tighten clockwise firmly. The chuck can be released by using one hole only. Note: The 3-Jaw Chuck is for use only in "Drill only" mode. The 3-Jaw Chuck is not for use when drilling with hammering action. FIG. 6 AUXILIARY HANDLE The auxiliary handle will provide additional control, support and guidance for the tool. The handle is adjustable around the 360° handle collar mount. To mount, loosen wing knob and slide handle completely over chuck onto the collar mount and tighten wing knob (Fig. 7). FIG. 7 WING KNOB AUXILIARY HANDLE DEPTH GAUGE Your drilling depth can be pre-set and/or repeated by using the depth gauge. Setting depth: After the auxiliary handle is installed, make sure the accessory has been fully inserted into the tool holder before setting the depth gauge (Fig. 8). To adjust depth, push down on the depth gauge release lever, slide the depth gauge to desired depth and release pressure on lever to lock the depth gauge in place (Fig. 8). FIG. 8 DEPTH GAUGE RELEASE LEVER DEPTH GAUGE -10-
![](/manual_guide/products/bosch-11536vsr-operating-instructions-240a07b/10.png)