Bosch 36614-02 Operating Instructions - Page 10
Caution, Warning
UPC - 000346381498
View all Bosch 36614-02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
BM 2610956386 07-08 7/1/08 1:25 PM Page 10 FORWARD/REVERSING LEVER & TRIGGER LOCK ! WARNING After tool use, lock trigger in "OFF" position to help prevent accidental starts and accidental discharge. Your tool is equipped with a forward/ reversing lever and trigger lock located above the trigger (Fig. 5). This lever was designed for changing rotation of the bit, and for locking the trigger in an "OFF" position. For forward rotation, (with chuck pointed away from you) move the lever to the far left. For reverse rotation move the lever to the far right. To activate trigger lock move lever to the center off position. ! CAUTION Do not change direction of rotation until the tool comes to a complete stop. Shifting during rotation of the chuck can cause damage to the tool. FIG. 5 GEAR SHIFTING Your tool is equipped with two separate gear ranges, low gear and high gear. Low gear provides high-torque and slower drilling speeds for heavy duty work or for driving screws. High gear provides faster speeds for drilling lighter work. To change speeds slide switch, to the high or low position (Fig. 6). ATTENTION: If your tool appears to be running, but the chuck will not turn, check to make sure the gear shifting switch is pushed fully into desired setting. ADJUSTABLE CLUTCH Your tool features 21 clutch settings. Output torque will increase as the clutch ring, is rotated from 1 to 20. The drill " " position will lock up the clutch to permit drilling and driving heavyduty work, and also enables bits to be changed quickly and easily in the keyless chuck (Fig. 6). BRAKE When the trigger switch is released it activates the brake to stop the chuck quickly. FIG. 6 GEAR SHIFTER ADJUSTABLE CLUTCH This is especially useful in the repetitive driving and removal of screws. BIT STORAGE AREA Your tool is equipped with a bit and storage area that is conveniently located in the handle base where it is always handy and unlikely to get lost or misplaced (Fig. 1). INSERTING AND RELEASING BATTERY PACK Set Forward/Reversing lever to the center (off position). Slide charged battery pack into the housing until the battery pack locks into position (Fig. 7). Your tool is equipped with a secondary locking latch to prevent the battery pack from completely falling out of the handle, should it become loose due to vibration. -10-