Bosch B36IT800NP Installation Instructions - Page 10

Required accessories and tools Supplied accessories  Installation instructions  Operating instructions  Installation kit Optional accessories Heater Kit for Side-by-Side installation XHEATKIT10 If the gap between the appliances is less than 6" (160 mm). Panel unification part (Metal strip) FPCONNBF10 For connection of two door panels. Can be used for standard height door panels without further preliminary work. Other required accessories Ice maker installation kit 1/4" OD copper line For connecting appliances which require water, e.g. for an ice maker. Other  Stepladder  Dolly, hand truck  Hammer drill for drilling holes in wall or floor  Bits according suitable for material and in different sizes  Wooden beam (cross section min. 3" x 4") as an alternative tilt protection, length according to the width of the installation cavity  Wooden screws in different sizes  Thin (max. 1/16" (1.5 mm)), suitable material to protect the floor from damage (e.g. lino)  Suitable material for covering and protecting furniture (e.g. protective sheets)  Adhesive tape Note: Before using, check whether the removed adhesive tape leaves adhesive residue on the work surfaces! Otherwise do not use on high-quality work surfaces. Tools Cordless screwdriver Torx bit T20 and T30 + magnetic holder Torx screwdriver T20 5/16" (8 mm) hex nut driver Wood drills in different sizes Open end wrench 1/2" (Width across flats 13 mm) Multigrip pliers Adjustable wrench Cutter with adjustable blade Metal tape measure, folding rule Square Level, length 2' (60 cm) and 4' (1,2 m) 10