Bosch HII8055U Installation Instructions - Page 7

Preparation Before You Begin Tools and Parts Needed • 40 or 50 Amp power supply cord kit with strain relief (depending on local code). Note: Not necessary for Canadian installations, cord is preinstalled at factory. • Measuring Tape • Phillips Head Screwdriver • 1¼" Wrench • Pencil • T-20 Torx Screwdriver • Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on mounting surface) • Level • Drill and Drill Bit (3/16" masonry bit for concrete screws) • Soapy Water • Safety Gloves and Goggles • Cloth or Cardboard (Optional - to Protect Floor) Parts Included • Anti-Tip Bracket • 2 wood screws • 2 anchorless concrete screws • Foam Tape (unless already installed on underside of cooktop sides) • Terminal lugs (for use with hard-wired installations) Note: Terminal lugs are not necessary for Canadian installations. Additional Parts Needed for Hard-Wired Installations • Flexible conduit • Torque wrench Note: Power supply cord kit is not necessary for hard-wired installations. Remove Packaging • If straps are present, cut the straps. • Cut plastic down back of unit making sure not to cut the unit. • Remove plastic film. • Lift cardboard around the top portion of the unit, off of the unit. English 3 • Remove cardboard corner posts, making sure that any posts or other packaging materials running between corner posts are also removed. • Remove all internal packaging and tape. • Leave bottom of packaging in place until it is close to the cabinet opening for the range. Installation Checklist Please refer to the pages following for complete installation instructions. Use this checklist to verify that you have completed each step of the installation process. This can help you avoid mistakes. ___ 1. Before installing the range, be sure to verify the cabinet dimensions are correct for your unit and that the required electrical connections are present. ___ 2. Refer to the installation manual for content regarding Safety, Cabinet Dimensions, Removing Packaging, Electrical Installation, Testing the Installation and Customer Service. ___ 3. Removing the oven door and warming drawer prior to installation reduces the unit weight and makes the range easier to move. Additionally, the removal of the oven door provides access to handhold for lifting. ___ 4. Move the range unit into place in front of the installation opening, leaving the bottom packaging on the unit to avoid damaging flooring. ___ 5. Plug the range into a properly configured receptacle. ___ 6. Protect the flooring from damage, then lift the range off of the bottom packaging and slide the range all the way into place, making sure to route the power cord correctly. ___ 7. Reinstall the oven door and warming drawer removed in step 3 above. ___ 8. Consult the complete installation instructions and follow the remainder of the procedures listed, including performing an operation test. 9001126425 Rev A