Bosch HMV5053U Installation Instructions - Page 5
Checklist for Installation, Before you begin - installation manual
View all Bosch HMV5053U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Checklist for Installation Use this checklist to verify that you have completed each step of the installation process. This can help you avoid common mistakes. Refer to detailed instructions for each step in the sections following this checklist. 1. Before installing the appliance, be sure to verify the cabinet dimensions are correct for your appliance and that the required electrical connections are present. Make sure the electrical cord provided on the appliance is able to reach to the point of connection. Sections: Location requirements, Electrical installation 2. Move the appliance into place in front of the cabinet opening. Section: Removing Packaging 3. Remove packaging materials, leaving the bottom packaging on the appliance to avoid damage to the floor. Section: Removing Packaging 4. Remove the mounting plate from the rear of the appliance. Section: Install Appliance - Removing the mounting plate 5. Find wall studs. Section: Install Appliance - Finding the wall studs 6. Attach the mounting plate to the wall. Section: Install Appliance - Attaching the mounting plate to the wall 7. Adapt the microwave blower. Section: Install Appliance - Adapting the microwave blower 8. Prepare the cabinet for mounting. Section: Install Appliance - Preparing cabinet 9. At least two persons are needed to lift the appliance; tilt and hook the appliance to the holding plate. Section: Install Appliance - Mounting the microwave oven 10. Push the appliance all the way into place and fasten the holding screws through top cabinet holes. Section: Install Appliance - Mounting the microwave oven 11. Use correct hood exhaust. Section: Install Appliance - Hood exhaust 12. Test the microwave oven for proper functioning. Section: Testing operation Always read and follow the complete installation instructions contained in this manual. Before you begin Removing Packaging 1. Remove filter, accessories and hardware. Do not remove the Styrofoam protecting the front of the oven. 2. Fold back all four carton flaps fully against carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam. 3. Pull the carton up and off the oven. 4. Cut the middle of the outer protective plastic bag to remove the mounting plate. Tools and parts needed ▯ Philips head screwdriver ▯ Pencil ▯ Ruler or tape measure and straight edge ▯ Drill ▯ Drill bits: 3/16", 1/2", 5/8" ▯ Gloves ▯ Saw (saber, hole or keyhole) ▯ Stud finder or hammer ▯ Safety goggles ▯ Level ▯ Duct and masking tape Optional tools ▯ Carpenter square ▯ Tin snips (to cut damper) ▯ Scissors (to cut cabinet template) ▯ Filler blocks or scrap wood pieces (for recessed bottom cabinet installations) 5