Bosch NGM5054UC Installation Instructions - Page 6

Countertop Requirements 30" Models 36" Models gas connection gas connection measurement in inches/mm measurement in inches/mm Mounting Requirements Use the mounting brackets supplied. See "Install the Cooktop" on page 5 for further details. Ventilation Recommendations We strongly recommend the installation of a ventilation hood above this appliance. The hood must be installed according to instructions furnished with the hood. Installation Procedure WARNING: To avoid electrical shock hazard, before installing the cooktop, switch power off at the service panel to prevent the power from being switched on accidentally. Prepare the Countertop Cut out the countertop per the dimensions shown in "Cabinet Requirements" on page 3. Some solid surface materials, such as Surell™ and Corian®, require different cutting methods. Consult with the Figure 2: Cutout Dimensions solid surface manufacturer for the correct cutting method needed. Apply heat reflective tape such as Scotch Aluminum Foil Tape #425 or #427 (not included) around the cutout so that it folds over on the top and sides. Do not wrap the tape underneath the cooktop. Be sure the tape extends beyond the outermost flange of the cooktop. All corners should be covered with tape. A A Cutout shows location of Aluminum Reflective Tape Heat Reflective Tape Section "A - A" Figure 3: Counter Cutout - Solid Surface Countertops Seal the Cooktop with Foam Tape Apply the self adhesive foam tape in one continuous rectangle directly to the counter around the perimeter of the cutout as shown by the dotted line in Figure 4: "Counter English 4