Bosch NGM8056UC Installation instructions 3 - Page 9

4. Insert each of the LP gas orifices provided with this kit into the socket (using the small piece of foam tape to assure a tight fit). Note: The NGMP056UC and NGMP656UC models have two orifices. The larger orifice should be installed in the center port and the smaller orifice should be installed in the port to the side. A Check to be sure the small piece of foam tape used earlier is fitted to wrap against one side of the socket. B When pressing the socket driver onto the orifice, the tape will help the orifice fit more snugly inside the socket. This will help prevent the orifice from falling out of the socket during insertion. $ %   Step 3 - Replace the burners, burner caps and grates Replace the burners, burner caps and grates. Be sure the grates are correctly placed and the rubber feet on the grates engage the indents in the cooktop for proper position. 9 WARNING The burner caps must be properly placed for the cooktop to function properly. If the burner cap is not properly placed, one or more of the following problems may occur: ▯ Burner flames are too high. ▯ Flames shoot out of burners. ▯ Stainless steel discolors. ▯ Burners do not ignite. ▯ Burner flames light unevenly. ▯ Burner emits gas odor. Burner Cap and Burner Base Placement ▯ The small hole or cutout near the edge of the burner should line up with the igniter. Rotate the burner until the igniter aligns with the electrode and gently lower it on to the cup. The burner should not be able to rotate when correctly placed on the cup. Pay special attention to avoid damaging the igniter during installation of the base. See Illustration below. ▯ Once each base is located and resting evenly, place each burner cap on its correct burner base. See Illustration. ▯ Place burner cap gently on top of base so that the prongs of the burner base fit snugly into the groove of the burner cap. ▯ If the maintop is removed by a certified installer (for example to check electrical or piping connection) the panhead screws that were removed must be reinstalled to ensure proper functionality of burners. 1 2 To prevent flare-ups, do not use the cooktop without all burners, burner caps and burner grates properly positioned. 9 WARNING To prevent burns, do not touch burners, burner caps or grates while hot. Turn the cooktop off and allow the burners to cool. Placing Burner Caps and Bases 9