Bosch SGE53B55UC Installation Instructions - Page 7

Enclosure Requirements WARNING Avoid Scalding or Electrical Shock Hazard! Make sure the water supply and electrical supply are shut off before installation or service. NOTE: This dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry. After locating the proper place for your new dishwasher, you will need to create any required openings to allow for passage of the water, drain and electrical line. In order to avoid interference with the dishwasher when sliding it into the cabinet, place your openings within the dimensions shown in Figure 3 below. Figure 3 Select a location as close to the sink as possible for easy access to water supply and drain lines. For proper dishwasher operation and appearance, ensure that the enclosure is square and has the dimensions shown in Figure 1 below. Figure 1 41/2" (114mm) 21/2" (64mm) 90° 22 5/8″ (575 mm) Required Openings: 2.5″ x 2.5″ (63.5 mm) - To to allow for water, drain and electrical lines on the appropriate side. 32-34¼″(813-870 mm) 235 /8 - 24¼″ (600 - 616 mm) NOTE: If your dishwasher opening width measures >235/8″ (600mm) use the TOP or SIDE MOUNT mounting methods. If your dishwasher opening width measures 235/8″(600mm) use the ALTERNATE SIDE MOUNT mounting method. If the dishwasher is to be installed in a corner, make sure that there is adequate clearance to open the door. See Figure 2 below. Before sliding the dishwasher into the cabinet, remove the hose clip at the back of the dishwasher as shown in Figure 4. The hose clip may be used later to hold the drain hose as shown in Figure 8. Figure 4 Check clearance between dishwasher door and wall Figure 2 Countertop In select models, remove the rubber apron on top of the dishwasher and set aside for later use. See Figure 5. Figure 5 WARNING Avoid Electrical Shock/Fire Hazard Do not allow the electrical and water supply lines to touch. 7 7