Bosch SGV63E03UC Instructions for Use - Page 13

Delay Start You can delay the start of the cycle in one hour increments up to 24 hours. To set delay start: 1 Open the door and press the [On/Off] button. 2 Press the [+] button until the display jumps to "h:01". 3 Press the [+] or [-] button until the displayed time corresponds with your requirements. h:01 = 1 hour delay h:24 = 24 hour delay 4 Press [Start] to activate delay start. To cancel delay start: 1 Press the [+] or [-] button until "h:00" is indicated on the digital display. 2 Press [Start] to save setting and close the door. Setting the amount of rinse aid The amount of rinse aid dispensed can be set from "r:00" to "r:06". To change the setting: 1 Open the door and press the [On/Off] button. 2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00". 3 Release both buttons. 4 Press the "A" button until the display shows "r:05". 5 Press the "C" button to select the desired setting. "r:00" = dispenser is OFF "r:01" = lowest setting "r:02" = low setting "r:03" = medium setting "r:04" = medium/high setting "r:05" = high setting "r:06" = highest setting 6 Press [Start] to save the setting and close the door. Cycle Completion Signal 1 Open the door and press the [On/Off] button. 2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00". 3 Release both buttons. 4 Press the "A" button until the display shows "b:02". 5 Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST 6 Press [Start] to save setting and close the door. Intensive Drying The final rinse uses a higher temperature which improves the drying results. The running time may increase slightly. To turn intensive drying on: 1 Open the door and press the [On/Off] button. 2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00". 3 Release both buttons. 4 Press the "A" button until the display shows "d:00". 5 Press the "C" button to turn intensive drying on or off. "d:01" = ON and "d:00" = OFF 6 Press [Start] to save setting and close the door. 11