Bosch SGX78B55UC Installation Instructions - Page 9

Inlet Water Connections Hot Water Supply The hot water heater should be set to deliver approximately 120° F (49° C) water to the dishwasher. Water that is too hot can cause some detergents to lose effectiveness. Lower water temperatures will increase run times. The hot water supply pressure must be between 15 - 145 psi (1 - 10 bar). IMPORTANT NOTES: ā ,IXVLQJDVROGHUMRLQWLQVWHDGRIDFRPSUHVVLRQ¿WWLQJEH sure to make all solder connections before connecting the water supply line to the dishwasher. ā 0DNHVXUHWKHUHDUHQRVKDUSEHQGVRUNLQNVLQWKHZDWHU OLQHWKDWPLJKWUHVWULFWZDWHUÀRZ · Always use the appropriate seal when making plumbing connections. · Before connecting the water supply line to the dishwasher, ÀXVKWKHLQFRPLQJZDWHUOLQHIRUDSSUR[LPDWHO\PLQXWHV to clear any foreign material. · Turn on the water supply and check for leaks after connections are made. WARNING Avoid Scald Hazard! Do not perform any work on a charged hot water OLQH 6HULRXV LQMXU\ FRXOG UHVXOW 2QO\ TXDOL¿HG plumbers should perform plumbing work. Do not attempt any work on the dishwasher hot water supply plumbing until you are certain the hot water supply is shut off. Temperatures required for soldering and sweating will damage the dishwasher. If plumbing lines are to be soldered or sweated, keep the heat source at least 6 inches (152.4 mm) away from the dishwasher. Water Supply Shut Off Valve Install an easily accessible shut-off valve (not supplied) in the hot water supply line, as shown in Figure 9. All solder connections must be made before the water line is connected to the dishwasher. 9 9