Bosch SHE23R56UC Short Instructions - Page 1
Bosch SHE23R56UC Manual
View all Bosch SHE23R56UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Getting started with your new dishwasher. 1 Adding Rinse Aid 3 Adding Detergent --Rinse aid is necessary to improve drying results. --Add rinse aid when the Rinse Aid LED on the control panel illuminates. --Lift the tab to open the rinse aid reservoir and add liquid rinse aid by pouring over the arrow. --Wipe up any excess rinse aid that may puddle. --Use fresh powdered detergent or detergent tabs for best results. --1 tablespoon will clean most loads --3 tablespoon max, do not overfill --When using detergent tabs, lay them flat to avoid contact with the cover. 3 Tbsp. maximum 2 Tbsp. (25ml) 1 Tbsp. (15ml) Recommended for best drying 2 Adjust Amount of Rinse Aid Dispensed --Turn the arrow inside the rinse aid dispenser to adjust the amount of rinse aid dispensed. To close the cover: --Place finger on arrow and slide cover fully left. --Push rear end of cover down firmly until it clicks. To open the cover: --Push the blue button inward (not down) and cover will slide open. 4 To Start the Dishwasher 1 To close the cover To open the cover 2 To decrease To decrease streaks on glass spots on glass --Press the On/Off button to turn dishwasher on. --Select a cycle and desired option if applicable. --Cycle will begin. Cancelling a cycle / Reset the dishwasher If you need to cancel a cycle or the dishwasher control panel seems to not respond, cancel or reset by following these steps. --Press and hold the two Cancel/Reset --Press the On/Off button. You may buttons for 3 seconds. now start a new cycle. If you choose --Wait about 1 minute while the dishwasher drains. to start a new cycle, turn the unit on again and select a cycle. Cancel/Reset To Optimize Drying Performance 1 - Always use Rinse Aid 2 - Use Auto Cycle (certain models) Frequently Asked Questions Dishes are not drying properly: Refer to section above. Odor: Debris at the bottom of the dishwasher or in the door seal can cause odor. Clean both according to instructions in the Use and Care Manual. Dishwasher still on after cycle ends: Default factory settings have the dishwasher stay powered on after a cycle ends. Customer must manually turn the dishwasher off. Dishwasher must be powered on again in order to start a new cycle. ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND IMPORTANT SAFETY NOTICES. Cycle Descriptions Heavy: Uses higher water temperature and pressure to remove baked-on foods Auto*: Reads the size and soil of each load, adjusting water and heat to the ideal balance for optimum cleaning results Normal: Cleans normal loads with loosely attached, normal soiling Delicate*: Uses lower water temperature and pressure, safe for delicate or heirloom dishware Express*: Cleans lightly soiled loads with reduced wash time Rinse & Hold: Rinses the soil off of a partial load and holds the dishes until you are ready to run a full load * Available wash cycles vary by model To Contact Customer Service Call the toll free Customer Service number, 1-800-944-2904. Before calling, locate the model number and serial number on the label on the inside of the dishwasher door. 9000643616 Rev A 3/11