Bosch SHE55M15UC Instructions for Use - Page 1
Bosch SHE55M15UC - 24"Evolution 500 Series Dishwasher Manual
UPC - 825225868989
View all Bosch SHE55M15UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
GETTING STARTED WITH YOUR NEW DISHWASHER FREQUENTLY ASKED QUESTIONS STEP 1- ADDING RINSE AGENT For Proper Drying Always use Rinse Agent even if your detergent containes Rinse Agent Rinse Agent Level • Add Rinse Agent when the light on the control panel illuminates • Lift tab to open or (Model Dependent) Rinse Agent Level indicator on the dispenser changes to a light silver color Run Time To save energy, this dishwasher has a "Smart Control" that automatically adjusts the cycle based on soil loads and incoming water temperature. The "Smart Control" makes decisions that can cause the cycle time and water usage to adjust at discrete times, and suddenly change in midcycle. The cycle times listed in the Use and Care manual are based on normal soil loads and 120°F incoming water and will vary based on your actual conditions. • To add Rinse Agent pour on the arrow • Turn arrow to adjust the amount of rinse agent dispensed Arrow Turn Decrease for Streaks on glasses Increase for Spots on glasses STEP 2 - ADDING DETERGENT 3 TBS MAX 2 TBS (25 ML) 1 TBS (15 ML) • Add Detergent • Use fresh powdered detergent for best results • 1 tablespoon will clean most loads • 3 tablespoons Max, do not overfill • When using detergent tabs, lay them flat to avoid contact with the cover 2 • To close Slide cover fully left 2 Push rear of cover down firmly until you hear the CLICK • If you should need to open the cover • Push the blue button in (NOT DOWN) When is the Cycle Complete Depending on model you can tell when your unit has completed the cycle in one of the following ways. Please refer to your Use and Care manual for complete details • Countdown Display at "0" • Clean Light illuminates • Cycle completion signal sounds (tone adjustable) • Cycle indicator light that shines on floor goes out Canceling a Cycle Be careful of splash-out. To cancel a cycle in process, press and hold the two buttons labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher as normal Cancel Drain 1 1 STEP 3 - TO START THE DISHWASHER 1) Close the door Exposed Front Controls 2) Turn on 4) The unit will then start 3) Select a cycle Hidden Top Controls 1) Open the door 4) Close the door to start 2) Turn on 3) Select a cycle To Contact Customer Service With the dishwasher door open, locate the label on the right side of the door. There you will find the: • Model Number • Serial Number (FD Toll Free Customer Service Phone Number ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND IMPORTANT SAFETY NOTICES. 9000121317 Rev. B • 02/06