Bosch SHE5AM02UC Use & Care Manual - Page 11

WARNING You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped. To cancel cycle: - Open door just far enough to expose the controls then press the "START RESET" button until the Active LED goes out. - Close the door and wait about 1 minute or until you hear the buzzer (if active) - Open the door and press "ON/OFF" Setting Options (rinse Agent amount / Extra Dry Heat / Cycle completion Signal) - Door must be open. Turn unit on. - Wash cycle LED will be flashing to indicate pre-select mode. - To enter setup mode press and hold then press and release "START RESET" button; then release . Active button will be flashing to indicate setup mode. - Press to select an option (Rinse Agent/ Extra dry heat/ Tone) - Press to adjust the settings for the respective options. (Press Start to save) To set Rinse Agent amount: Active + Rinse Agent LED flashing. Follow steps under setting options above NOTE: If your glasses have spots you need more Rinse Agent. If your glasses have streaks you need less Rinse Agent. Power Scrub Regular Wash Quick Wash Rinse Aid Setting 0 (least) 1 2 3 4 5 6 (most) To set Extra Dry Heat: Active + Sanitized LED flashing . Follow steps under setting options above Power Scrub Regular Wash Quick Wash Extra dry Heat not activated activated To set Cycle Completion Signal: Active + Rinse Agent LED flashing. Follow steps under setting options above Power Scrub Regular Wash Tone setting 0 Low Medium High 11