Bosch SHE65T55UC Instructions for Use - Page 22
Self Help
View all Bosch SHE65T55UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Self Help Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following information may help you with a dishwasher problem without involving a repair professional. Problem Cause Action Dishwasher does not start 1. Door may not be properly 1. Shut the door completely until you latched hear a click 2. Unit may not be turned on 2. Press the main power switch to 3. Unit not reset or previous cycle turn unit on not completed 3. To reset, refer to "Cancel a Cycle" 4. Delay start engaged section in this manual 5. Interruption of electrical power 4. To reset, refer to "Delay Start" supply to dishwasher or blown fuse. section in this manual 6. The door may have been closed 5. Check circuit breaker without first selecting a cycle 6. Select a cycle and close the door. 7. Water supply may not be turned on 7. Check and turn on water supply Display does not illuminate 1. A fuse may have been blown or circuit breaker tripped 2. Door not closed or latched Note: For models with controls on top of the door, the display only illuminate when the door is opened and controls are visible. 1. Check the fuse or circuit breaker box and replace the fuse or reset the breaker if necessary 2. Ensure door is properly latched and completely closed Dishwasher seems to run a long time 1. Incoming water is not warm enough 2. Cycle time can vary due to soil and water conditions 3. Rinse aid dispenser is empty 4. Dishwasher connected to cold water supply Note: Refer to "Wash Cycle Information" section in this manual for typical cycle lengths. 1. Before starting a cycle, run hot water faucet at the sink closest to the dishwasher 2. Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected 3. Add rinse aid 4. Verify dishwasher is connected to hot water supply plumbing Dishes are not getting clean enough 1. Spray arm movement obstructed 2. Spray arm nozzles clogged 3. Improper use of detergents 4. Filters could be clogged 5. Dishes are nested or loaded too close together 6. Selected wash cycle is not suitable for food soil conditions 1. Ensure that spray arm movement is not blocked by hand rotating spray arms before starting cycle 2. Remove the spray arms and clean according to the "Care and Maintenance" section of the manual 3. Increase or decrease detergent depending on the water hardness 4. Clean the filters according to the "Care and Maintenance" section of the manual 5. Rearrange load such that water spray can reach all items in the dishwasher - see "Loading the Dishwasher" section of the manual 6. Refer to "Wash Cycle Information" section of the manual 21