Bosch SHE66C02UC Installation Instructions - Page 17

Base and Toe Panel/ Final Instructions BASE AND TOE PANEL (Continued) c a b d Figure 34 Plastic Base Access Panel and Toe Panel Installation (SHY66C, SHX99A, SHE66C, SHE99C, SHX57C, and SHV57C models only) 1 Place the Plastic Base Access Panel under and up the front bottom panel of the dishwasher, as shown in Figure 34a. 2 Insert the Plastic Base Access Panel screws into the Plastic Base Access Panel, as shown in Figure 34b. Tighten the Plastic Base Access Panel Screws. 3 Place the Cotton Insulation Strip under the unit, between the bottom of the Plastic Base Access Panel and the floor, as shown in Figure 34c. 4 Attach the Toe Panel to the Plastic Base Access Panel using the Toe Panel Screws included in the Toe Panel Installation Kit. See Figure 34d. NOTE: You will not use the normal Toe Panel Screws included in the Dishwasher Installation Kit on these models. WARNING In some conditions, Hydrogen gas can form in a hot water system that has not been used for weeks. Hydrogen gas is explosive. Before filling a dishwasher from a system that has been off for weeks, run the water from a nearby faucet in a well ventilated area until there is no sound or evidence of gas. FINAL INSTRUCTIONS 1 Energize the dishwasher power supply circuit. 2 Consult the Dishwasher Use and Care Manual, and run the dishwasher through one complete cycle. If the dishwasher does not operate properly, refer to the SelfHelp section of the Use and Care Manual. If the dishwasher still does not operate properly, refer to the Customer Service Section of the Use and Care Manual. 15