Bosch SHE9PT55UC Installation Instructions - Page 11
Leveling The Dishwasher, Securing The Dishwasher
View all Bosch SHE9PT55UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
~1/2″ (12mm) WARNING Avoid Tip Over Hazard Do not use the dishwasher until it is completely installed. When opening the door on an uninstalled dishwasher, carefully open the door while supporting the rear of the unit. Failure to follow this warning can result in serious injury. LEVELING THE DISHWASHER The unit should now be ready to slide into the cabinet opening. To avoid scratching the loor, use loor protection and caution when sliding the dishwasher into the cabinet. Make sure that the hoses and cords do not bunch up behind the unit or kink as you slide the unit back. Make certain to slide the unit into place before raising the leg levelers. Level the dishwasher horizontally by turning feet clockwise to raise or counter-clockwise to lower front of the unit. Level the dishwasher vertically by turning center screw to raise or lower the back. Figure 20 Drive the mounting screws through the holes in the mounting brackets as shown for Top (Figure 23), Side Mount (Figure 24) and Alternate Side Mount (Figure 25). Figure 23 For Top Mount - Wooden 1/16″ (2mm) D Figure 24 For Side Mount - Stone Countertop 0 - 23/8″ (0-60mm) SECURING THE DISHWASHER Center the dishwasher in the opening before securing it to your cabinet or countertop as shown in Figure 21. Remove the top cutlery rack as shown in Figure 22. Figure 21 D ~1/2″ (12mm) Figure 25 For Alternate Side Mount 1/16″ (2mm) Figure 22 N 11