Bosch SHEM78W52N Instructions for Use - Page 30
Warning, Caution
View all Bosch SHEM78W52N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
en-us Operating the Dishwasher To change the setting: 1. Press the On/Off button (. 2. Hold down the function key # and press the Start button P until the display 8 indicates š:‹x (x can be any number). 3. Release both buttons. 4. Press the function key # until the display 8 indicates ˜:‹x. 5. Press the function key 3 until the display corresponds with your requirements. 6. Press the Start button P. Interrupting the wash cycle 9 CAUTION Expansion (overpressure) may cause the appliance door to open and/or water to escape! If the door was opened on an appliance which has a hot water connection or is heated, always leave the door ajar for several minutes and then close. Switching off the appliance Short time after the end of the wash cycle: 1. Press On/Off button (. 2. Turn off water supply. 3. Remove the utensils when they have cooled down. 9 WARNING RISK OF INJURY! To avoid risk of injury, always use caution when opening the door during or following a wash cycle as hot water or steam may escape. Do not fully open the door until water noises have stopped and steam has subsided. 1. Press On/Off button (. The LED's go out. The wash cycle is saved. 2. To continue the wash cycle, close the door and press On/Off button ( again. Note: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds after pressing the Start button, the operation will be paused. Close the appliance door and press the Start button P again. Terminating the wash cycle (Reset) 1. Press and hold Start button P elcychsawehtgnitanimreT for approximately 3 seconds until the display reads ‹:‹,. 2. Wait about 1 minute while the dishwasher drains. 3. Press On/Off button (. You may now power the dishwasher back on and begin a new cycle if desired. Changing the wash cycle When the Start button ( has been pressed, the wash cycle cannot be changed. The only way a wash cycle can be changed is by terminating the wash cycle (Reset). 30
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84
-
85
-
86
-
87
-
88
-
89
-
90
-
91
-
92