Bosch SHP9PCM5N Installation Instructions - Page 15
Installing the Drain Connection
View all Bosch SHP9PCM5N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
effectiveness. Lower water temperatures will increase run times. The hot water supply pressure must be between 15 - 145 psi (1 - 10 bar). WARNING Scalding Hazard ▶ Do not perform any work on a pressured hot water line. Serious injury could result. Only qualified plumbers should perform plumbing work. Do not attempt any work on the dishwasher hot water supply plumbing until you are certain the hot water supply is shut off. NOTICE: Soldering plumbing lines ▶ Temperatures required for soldering and sweating will damage the dishwasher. If plumbing lines are to be soldered or sweated, keep the heat source at least 6 inches (152.4 mm) away from the dishwasher. Plumbing codes ▶ Check local plumbing codes for approved plumbing procedures and accessories. All plumbing should be done in accordance with national and local codes. Note Important notes for water connection: ¡ If using a solder joint instead of a compression fitting, be sure to complete all solder connections before connecting the water supply line to the dishwasher. ¡ Use an approved dishwasher water supply line with the correct fittings for this connection. ¡ If using copper tubing or other material not depicted in this manual for water supply, defer to a licensed plumber for proper installation. ¡ Always use appropriate seals when making plumbing connections. 1. Flush the incoming water line for approximately 1 minute to clear any foreign material. 2. Connect the dishwasher water supply line to the water shut off valve. ‒ Install a shut off valve if one isn't already in the supply line. ‒ Make sure there are no sharp bends or kinks in the water line that might restrict water flow. Dishwasher Connection en-us 4. After all connections are made, turn on the hot water and check for leaks. 5.2 Installing the Drain Connection The drain hose must be installed with either a high loop or an air gap. NOTICE: Proper drain hose installation ▶ The dishwasher drain hose must be installed with a portion of it at least 33" (84 cm) off the floor; otherwise the dishwasher may not drain properly. Remove garbage disposal plug ▶ If the dishwasher drain hose will be connected to a garbage disposal connection, first remove the plug from the disposal connection. Note Important notes for drain connection: ¡ If local ordinance require an air gap, install it according to the manufacturer's instructions. ¡ The drain hose length can be extended if necessary. Use kit #SGZ1010UC. The maximum length of the drain hose, including the hose leading to the air gap, is 150″ (380 cm). ¡ You may attach the hose clip the inside of the adjacent cabinet to hang the drain hose (screws are not supplied) in place of using a nonmetallic tie as pictured in the next illustrations. Do not exceed 43" in drain hose height. 1. Place hose clamp around end of drain hose BEFORE connecting to the plumbing. 2. If you have a garbage disposal, connect the drain hose to the garbage disposal with either a high loop or an air gap. 3. Properly tighten all water connections. 15