Bosch SHV78CM3N Installation Instructions - Page 14
Dishwasher Connection
View all Bosch SHV78CM3N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
en-us Dishwasher Connection 3. If your model has a rubber apron, tuck it behind the tabs on the metal brackets as shown. 2. Attach using 2 of the included 3/4" (19mm) screws. ‒ Use only the included screws to avoid damaging the dishwasher. 4. Slide toe panel into position ensuring the bottom of the toe panel is flush with the floor. 5. Use the 9/16" (14mm) toe panel screws to mount the toe panel through the hole it matches up with on the metal brackets. 3. Slide the slotted toe panel into position ensuring that the bottom of the toe panel is flush with the floor. 4. Screw the slotted toe panel into place with the remaining 3/4"(19mm) screws. The toe panel height can be adjusted by screwing into a different hole in the bracket. 6. If your model has a rubber apron, open the door to make sure that the apron is in the correct position. Ensure the apron does not bind up and can freely move up and down behind the toe panel. 4.12 Attach Plastic Toe Panel If your dishwasher came with a plastic toe panel and slotted toe panel, follow these instructions. 1. Align the plastic toe panel on the base of the dishwasher so the holes lines up. Dishwasher Connection 5 Dishwasher Connection Dishwasher Connection Follow these instructions to connect the dishwasher. 5.1 Installing the Water Inlet Connection The hot water heater should be set to deliver approximately 120° F (49° C) water to the dishwasher. Water that is too hot can cause some detergents to lose 14