Bosch WFMC530SUC Installation and Use & Care (all languages) - Page 19
Washing
View all Bosch WFMC530SUC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Washing time is extended. Only cold water is introduced to the drum. The washing machine then heats the water to the selected wash temperature. By raising the temperature from cold up to the set temperature all components of the detergent are activated in stages for best stain removal and cleaning results. Acoustic Signal An acoustic signal indicates program statuses (e.g. start/end of program and operating faults.) To activate the signal: q Select a program. q Press two of the Option Buttons(e.g. Bleach and Rinse Plus) until a long signal is emitted. To deactivate the signal: q Select a program. q Press two of the Option Buttons and hold until a short signal is emitted. i Do not activate/deactivate the acoustic signal during a cycle. Indicator light above the Start/Pause" button The indicator light conveys the following information: - Indicator light flashing red: Program can be started. - Adding laundry is possible. - Indicator light is lit red. Program is running. - Adding laundry is not possible because the door is locked for safety reasons. Laundry may be added after pressing the Start/Pause button. Special features Auto Load adjust Auto Load adjust" adjusts the water and energy consumption for each program and determines the amount of laundry and type of fabrics. This process is built into your machine and occurs automatically. This control reduces water and energy consumption when washing small loads. Unbalanced load detection system The automatic unbalanced load detection system spins the laundry several times to ensure even distribution. If the wash load is unevenly distributed, it will not spin (for safety reasons) or the final spin speed is reduced. In the wool program the appliance will attempt to start the spin cycle only twice in order to prevent shrinking. Displayed Time Due to these and other characteristics of the controls the actual cycle time will vary. When a program has been selected, the expected program duration is displayed. The following will effect the displayed time: - Load size - Repeated spin attempts to evenly distributed load - Additional rinse cycles if excessive foam occurs - Water pressure is too low - Selection of additional options, e.g. Rinse plus" i You may notice these effects (more or less time) changes the displayed time when they occur in the cycle. If no options are selected and these effects do not occur, the time indicated will count down until the end of the cycle. Washing q Turn on the water taps. q Turn the program selector to the desired program. q Load the washing machine and close the door. The Start/Pause indicator light flashes (red). q If necessary, press the button(s) for additional option(s). The indicator light of the selected button is lit (red). i If an incorrect combination was inadvertently selected, the indicator light of the selected button is turned off. 19