Bosch WFMC8401UC Installation and Use & Care (all languages) - Page 30

Fault Program does not start. "Real Time delay" is indicated in the display field. Clock cannot be set. "Set clock:" text remains in the display field even though the Menu button has been pressed. No time displayed. End time cannot be selected. Spin speed cannot be selected. Child lock cannot be selected. Detergent residue in the detergent dispenser. Water does not enter the machine or detergent is not washed away. "Water tap closed?" indicated in the display field. Water cannot be seen in drum. Washing solution has not drained completely. "Suds or blocked pump?" indicated in the display field. Water is flowing out from underneath the machine. Suds coming out of the detergent dispenser. Repeated spinning. The laundry was not spun. Program duration extended. Possible cause End time selected and activated. Program has already started; when a program has started, the clock cannot be set. The setting has switched from hours to minutes; both selection points have the same text. Time not set. Time not set. Program has already started; when a program has started, the end time can no longer be selected. Spinning is already in progress; during spin cycle the speed cannot be changed. The program has already started. Detergent was damp or lumpy. Water tap not turned on. Supply hose kinked or pinched. Strainers in supply hose clogged. Water pressure too low. This is not a fault. The water level is below the visible part of the drum. Suds or pump is blocked The thread of the supply hose is not tight. Leak in the drain hose. Too much soap or non-HE soap used, pump could not remove suds. This is not a fault. The imbalance compensation system is attempting to balance the load through repeated spins. Large items of clothing have become entangled and could not be distributed evenly in the drum. For reasons of safety the highćspeed spin cycle was automatically suppressed. This is not a fault. The suds detection feature has activated an additional rinsing cycle to reduce the amount of suds. This is not a fault. The imbalance compensation system is attempting to balance the load through repeated spins. Action None. Appliance starts automatically. Wait until program ends. None. Set time; see Page 15. Set time; see Page 15. Before starting the program, select and start the desired end time; see Page 22. Select speed before spinning. Child lock can be selected in pause mode. Clean and dry the detergent dispenser; see Page 27. Use the cap of the detergent bottle to measure liquid detergents. Turn on water tap. Program continues. Eliminate the cause. Clean the water inlet strainers; see Page 27. Eliminate the cause. Use less detergent for future wash loads. Detergents specifically designed for your High Efficientcy washer produce fewer suds and will include the letters HE" on the packaging. Clean the water drainage pipe and/or drain hose. Tighten the thread. Replace the drain hose. Mix 1 tablespoon of fabric softener with 1 pt (½ litre) of water and pour into detergent dispenser I. Use less detergent for future wash loads. Detergents specifically designed for you High Efficientcy washer produce fewer suds and will include the letters HE" on the packaging. Always load the drum with large and small items together. Always load the drum with large and small items together. Add a more appropriate amount of detergent. Always load the drum with large and small items together. 30