Bosch WTMC4321US Pedestal Installation Instructions - Page 4
Installing, Pedestal - manual
View all Bosch WTMC4321US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Preparing Your New Appliance 1. Position the original packaged appliance close to the final location. Using a utility knife, cut the two packaging straps. NOTICE If installing the pedestal to a new washer, do not remove the washer transportation bolts prior to installing the pedestal. 2. Remove the protective film, four corner supports, and two foam packaging pieces. 3. Protect the floor and the side of the appliance by laying a sufficiently large piece of cardboard (such as the pedestal carton) or other suitable protective covering flat on the floor to the left of the unit. Support the appliance approximately 1 1/2" to 2" off the floor. Helpful Hint: Place the two corner supports from your appliance packaging (see Figure 5). If corner supports are not available, items such as rolled up towels can be used. Figure 5 4. Lay the appliance on its LEFT side (see Figure 6). Note for Washers: Slight water spillage may be noticed due to laying washer on its side. Figure 6 5. Remove the bottom of the packaging. 6. Go to Installing the Pedestal" section of this manual. Installing the Pedestal d CAUTION Do not place fingers near the bottom of the pedestal while moving the drawer. Doing so can result in a cut or pinch injury. 1. Remove the feet originally installed in the appliance (see Figure 7). DO NOT reinstall these feet into the pedestal. Retain the feet in case the appliance needs to be reinstalled later without the pedestal. the floor under the pedestal. Remove the drawer from the pedestal by depressing the drawer release levers located in the drawer slide rails. Set the drawer aside. Helpful hint: It is recommended to have an assistant hold the pedestal housing during drawer removal. Push up on the drawer release lever on the left side and down on the drawer release lever on the right side while removing the drawer (see Figure 8). Figure 8 d CAUTION Excessive Weight Hazard Use two or more people to install the pedestal. Failure to do so can result in injury. 3. Place the top of the pedestal against the appliance bottom. Ensure the pedestal drawer opening and appliance door face the same direction (see Figure 9). Helpful hint: Foam packaging may be used to help align the pedestal and the appliance. Figure 7 2. Protect the floor and the side of the pedestal by laying a sufficiently large piece of cardboard or other suitable protective covering flat on 4