Bosch WTMC533SUS Operating, Care, Installation (French) - Page 21
Operation
View all Bosch WTMC533SUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Operation Using the dryer 1. Open the door. 4. If required, select an available option ("Delicates low temp" or ECO e") by pressing the corresponding button (see figure above). All available "Options" are explained on page 18. i The estimated remaining time will be displayed. 2. Check lint filter. The filter should be cleaned before and after using the dryer. Cleaning the filter reduces the drying time and saves energy. (See page 22 for lint filter cleaning instructions). i Bleach may cause discoloration of the dryer's colored surface. Therefore, it is important to keep bleach away from the colored surface of your dryer. If any bleach spills on the surface, use a moist paper towel to thoroughly clean it immediately. 5. Place laundry in the empty drum. Put each piece of laundry into the machine separately. For best results the laundry to be dried must be sorted according to type of laundry and desired degree of drying. For further information see page 17. i Observe drying symbols of the laundry manufacturer. If drying woolen clothing and shoes, see the information on page 22. Ensure that there is only laundry in the drum. Check that all items are completely in the drum. 6. Close the door. 3. Rotate program selector to the desired program. Select the program which corresponds to the laundry in the dryer from the program selection table (see page 18). The dryer light turns on inside the drum. i The Start/Stop" indicator light starts flashing. The Start/Stop" indicator light continues flashing. i If the door has not been closed properly, the dryer will not start. 7. Press the Start/Stop" button. The Start/Stop" indicator light illuminates. i The program starts with an acoustic signal (if set). If a standard program has been selected, the indicator lights indicate the progress of the program sequence. i At program end an acoustic signal is emitted (if set) and the LED Wrinkle block" illuminates. i When the drying process is complete (program or selected time program ended), the drum rotates at specific intervals for 1 hour. This prevents the laundry from creasing. The laundry remains loose and fluffy until it is removed. The laundry should be removed before this time has elapsed. 8. Open the door. 9. Take the laundry out of the dryer. 10. Rotate the program selector to Off". The dryer light goes out. 11. Clean the filter. The filter should be cleaned after each drying process. Cleaning the filter reduces the drying time and saves energy. 12. Close the door. 21