Bose 321 GS Series II Owner's guide - Page 24
Connecting the power cord
View all Bose 321 GS Series II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
SYSTEM SETUP Svenska Nederlands FItralniaçnaois DEsepuatsñcohl EDnagnlisskh SYSTEM SETUP Connecting the power cord CAUTION: For dual voltage models only, be sure to set the dual voltage switch on the back of the Acoustimass® module to the appropriate voltage for your area (115V or 230V) before connecting to power. If you are not sure about the proper voltage for your area, consult your local electrical authorities. 1. Insert the small connector end of the power cord into the AC INPUT connector on the Acoustimass module (Figure 20). 2. Insert the large end of the cord into an AC power (mains) outlet. Note: On 220-240V models only, turn the Acoustimass module POWER switch to on (l). Figure 20 Connecting to power AC input jack Note: Provided only on 220-240V rated systems. AC power switch 115/230V selection switch Note: Provided only on 115/230V dual voltage rated systems. Note: Bose recommends using a safety agency-approved surge protector on all electronic equipment. Voltage variations and spikes can damage electronic components in any system. A quality suppressor can eliminate the vast majority of failures attributed to surges and may be purchased at electronics stores. 24