Bose Acoustimass 3 Series IV Owner's guide - Page 9
Checking your connections - speakers set
UPC - 017817497817
View all Bose Acoustimass 3 Series IV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Figure 4 Completed connections Setting Up Your Acoustimass® 3 Speaker System 4. Connect the free end of the left (L) INPUTS cable to the LEFT speaker terminals of your amplifier or receiver. Connect the marked wire to the positive (+) terminal and the plain wire to the negative (-) terminal. 5. Connect the free end of the right (R) INPUTS cable to the RIGHT speaker terminals of your amplifier or receiver. Connect the marked wire to the positive (+) terminal and the plain wire to the negative (-) terminal. CAUTION: Before you plug in your receiver or amplifier, make sure that no strands of wire from any terminal are brushing against any other terminal. Such "bridged" wires create short circuits which can damage your receiver or amplifier. - R+ OUTPUTS TO CUBE SPEAKERS - L+ - R + - INPUTS FROM AMP OR RECEIVER L + Checking your connections To avoid damaging your speakers, check all connections and correct any problems before plugging in and turning on the amplifier or receiver. Make sure the cube speakers are connected to the module and not directly to the amplifier or receiver. AM252171_02_V.pdf October 22, 2001 7