Bose Model 101 Music Monitor Series II Owner's guide - Page 2

© 1997 Bose Corporation The Mountain, Framingham, MA 01701-9168 AM190197 Rev.02 The Bose® 101® Series II Music Monitor® Speaker System Owner's Guide FPO Introduction Thank you for purchasing the Bose 101 Series II Music Monitor speaker system. It is designed to deliver true high fidelity sound when connected to almost any receiver. Unpacking Your 101 Series II Speakers Both 101 speakers are packed in one carton. Unpack the carton carefully. Save it and the packing materials for possible future use. Connecting Your 101 Series II Speakers Speaker cord consists of two insulated wires. The insulation around one wire is marked (striped, collared, or ribbed). This marked wire is always positive (+). The plain wire is always negative (-). These wires correspond to the red (+) and black (-) terminals on the speakers and the receiver. See Figure 1. 1. Strip approximately 1⁄2" of insulation from each end of both speaker wires. 2. Press the terminal tab on the back of each speaker to insert the appropriate wire. See Figure 2. Connect one speaker cord to your right speaker. Attach the marked wire at one end to the red (+) terminal. Attach the plain wire at that end to the black (-) terminal. 3. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of your receiver. Attach the marked wire to the red (+) terminal. Attach the plain wire to the black (-) terminal. 4. Connect the second cord to the left speaker and LEFT SPEAKER OUTPUT. Follow the steps in 2 and 3 above.