Boss Audio 625UAB User Manual in English - Page 4

Common operation: 1. To turn the unit on/off . When the unit is power Off, it may be switched On by pressing any button except RELEASE button. When the unit is switched On, press and hold POWER button for more than 0.5 seconds, to switch the power off. 2. To select function mode Press SRC button to change function mode as follows: -->TUNER -->USB(after inserting USB stick)-->CARD(after inserting SD card)-->BT--> AUX--> When there is no media (USB/CARD), that mode will be skipped. 3. To adjust the volume level Rotate VOL knob or press + or - button on remote control to adjust volume level during playback. 4. To mute or resume sound Press MUTE or MU button to eliminate or resume sound immediately during playback. To resume the sound immediately, you can rotate VOL knob. 5. To set sound mode and menu 1).To set sound mode: Press SEL button shortly and repeatedly to select mode of VOL(volume), BASS (without preset DSP), TRE(treble)(without preset DSP), BAL(balance) and FAD (fader) in the sequence and circulation. In each mode, the waiting time is about 5 seconds, and when the waiting time is over, it will return to the last display mode. After selecting a sound mode, use volume control to set level of the selected sound mode. 2).To set menu: Press SEL button and hold for more than 2 seconds to turn on BEEP ON/BEEP OFF, then press SEL button shortly and repeatedly to select USER SET (FLAT/CLASSIC/ ROCK/POP), VOL LAST/VOL DEFA(AVOL) , AMERICA3/EUROPE(in RADIO mode), STEREO/MONO(in RADIO mode), LOUD OFF/LOUD ON, DX/LOCAL(in RADIO mode) mode. After selecting a desired item, use volume control to set. 3) BEEP ON/BEEP OFF BEEP ON mode: The beep is generated when any key is pressed. BEEP OFF mode: The beep sound is disabled. 4) VOL LAST/VOL DEFA VOL LAST: The volume level when switching off will be restored with power On. VOL DEFA: The volume level of the main unit after power on is a constant value. when selecting VOL DEFA item, press SEL button to display AVOL , then you can pre-set the constant volume level after power on with VOL control. 6. ID3 FUNCTION In USB/CARD mode, during playback, if you press DISP button or DSP button on remote control then the information of the songs title, artist, etc will display on the LCD. As long as the current playing music contains relevant ID3 tag information. Press again to cancel the ID3 function. Page 3 PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com INSTALLATION METHOD This is an anti-theft installation method. The main unit wears a METAL MOUNTING SLEEVE. Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below. To boost up the capability of anti-jamming, please make sure fix tightly the metal support strap into the metal joint that connect to the chass is of the car. METAL SUPPORT STRAP UNIT CHASSIS Bend the tabs on the metal mounting sleeve against the DASHBOARD with a screwdriver DASHBOARD METAL MOUNTING SLEEVE FIXED FACEPLATE FRONT PANEL PLASTIC TRIM RING To remove the unit out of the metal mounting sleeve, insert the two supplied KEYS into the left and right side slots of the chassis at the same time. Then pull the chassis out of the metal mounting sleeve as shown in the right illustration. Page 8