Boss Audio CER450.2 User Manual in English - Page 7
Remote, Subwoofer, Control, Audio, Outputs, signal, processor
View all Boss Audio CER450.2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
High Level Input Wiring The high level input(s) should only be used when your head unit lacks RCA outputs. If the RCA outputs are not present, connect the speaker outputs from the receiver to the high level input connector of the amplifier. Be sure to observe polarity to avoid audio phase problems. NOTE:Do not connectBOTH the high levelandlowlevelinputs from your receiver to your amplifier at the same time! MonoBlock Amplifier CER1200M 0 ••000 3055 ..u=m BASS BOOST in••••0 am••• CROSSOVER INPUT CONTROLS 0 ...WEE 0 PECTECCON 0 0 INP L+ L- R- To Speaker Terminals of head unit 0 I=II=II=II=II=II=I Remote Subwoofer Control MonoBlock Amplifiers CER1700M, CER2100M BONS ° 0 0 LEVEL LOW 0 0 0 0 L+ L- R- R+ O 000000 To Speaker Terminals of head unit CHAOS ERUPT MOSFET Amplifier User's Manual-page 9 Remote Subwoofer Control Low Level Input Wiring Low-level (RCA) input wiring is preferred for best audio performance. Always use a high-quality RCA cable for best audio performance. NOTE:Donot connectBOTH the high levelandlow levelinputs from your receiver to your amplifier at the same time! 2-Channel Amplifiers CER350.2, CER450.2, CER700.2 Remote Subwoofer Control 0 0 0 MON I.EVM. LOW LEVEL 30NS L r= , 120 IN LOY/ I.00 FRECLII• LW/ NM BBB MIN REMOTE RDEV/00FER LEy.L RILL RAABE MODE CONTROL O To Audio Outputs of head unit or signal O processor 4-Channel Amplifiers CER250.4, CER350.4, CER450.4 Remote Subwoofer Control CR0WCO/W9-LOVIRM• COW J :O. 0NS CH3 Neu CD CH3 MIN LOWI MN CROWENER MOUE CH CONTROLS RWACTE I L WORMS 0 mw. C) mum-rm. ° =.H3_ O To FRONT Audio Outputs of head unit or signal processor O To REAR Audio Outputs of head unit or signal processor CHAOS ERUPT MOSFET Amplifier User's Manual-page 6