Boss Audio MGR450B User Manual - Page 1
Boss Audio MGR450B Manual
View all Boss Audio MGR450B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
USER MANUAL QUICK INSTALLATION GUIDE MGR450B BLUETOOTH® (Audio Streaming) Marine Gauge Digital Media AM/FM Receiver FEATURING ZERO STANDBY CURRENT DRAIN USER MANUAL QUICK INSTALLATION GUIDE MGR450B BLUETOOTH® MARINE GAUGE DIGITAL MEDIA AM/FM RECEIVER iPod® and iPhone® are registered trademarks of Apple Inc. registered in the USA and other countries. BOSS Audio Systems is not affiliated with Apple Inc. BOSS Audio Systems 3451 Lunar Court • Oxnard, CA 93030 www.bossaudio.com 800-999-1236 US Toll-free 805-751-4853 Customer Service tech support: www.bossaudio.com/support/technical-support 0417 VER:1.0 EN Copyright © 2017 PRINTED IN CHINA Thank you for purchasing this MGR450B Bluetooth Marine Gauge Digital Media AM/FM Receiver Please read thorough these instructions carefully so you will know how to operate your model properly. After you have finished reading the instructions, keep this document in a safe place for future reference. THIS PACKAGE CONTAINS INFORMATION TO THE USER The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license. Other trademarks and trade names are those of their respective owners. FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. The Bluetooth antenna cannot be removed (or replaced) by user. This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20 cm or more away from person's body (excluding extremities: hands, wrists, feet and ankles). Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Relocate or reorient the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. !! WARNING !! ADJUSTMENT OR ALTERATIONS OF THIS DEVICE MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. 1 IMPORTANT SAFETY PRECAUTIONS BE SURE TO OBSERVE THE FOLLOWING GUIDELINES: • Do not turn up the volume so high that you can't hear what's around you. • Use caution or temporarily discontinue use in potentially hazardous situations. • Do not operate mobile video equipment while driving a motorized vehicle - safe driving and safety consideration of others should always be your highest priority. • Set your volume control at a low setting, then slowly increase the sound until you can hear it comfortably without distortion, or ear discomfort. • In the event you should notice smoke, strange noises or odor from this product, or any other abnormal signs, immediately turn off the power and consult your dealer or the nearest authorized BOSS AUDIO Service Center Using this product in this condition may result in permanent damage to the system. BEFORE YOU START INSTALLATION PRECAUTIONS Always consult with a professional installer • Do not attempt to install or service this product by yourself. Installation or servicing of this product by persons without professional training and experience in electronic equipment and motorized vehicle accessories may be dangerous and could expose you to the risk of electric shock, injury or other hazards • Refer any repairs to a qualified BOSS AUDIO SYSTEMS Service Center • The MGR450B should be wired directly to a vehicles battery • When wiring directly to the vehicles battery, be sure to disconnect the batteries negative terminal wire before starting any wiring procedures, if extending the main power primary wire, it is suggested that an optional fuse and fuse holder (not included) with minimum rating of 20 Amperes be in-line with the positive battery terminal • The ground cable length should be as short as possible, if extending from you battery, be sure to use a proper gauge rating for the length of the run, use only high quality copper primary type wire • The MGR450B has a IPX6 weather resistant design, it should not be submerged in or under water under any circumstances • Do not use abrasive cleaning materials on the lens or bezel • Use only the installation parts provided with the MGR450B To avoid potential shorts in the electrical system, be sure to disconnect the (-) battery cable before installation. Use this unit with a 12-Volt battery and negative grounding only. Failure to do so may result in a fire or malfunction. When replacing the fuse, be sure to only use a fuse of the rating specified on this product. To avoid short-circuiting, cover any disconnected leads with insulating tape. It is specially important to insulate any unused wires, which if left uncovered may cause a short circuit. When connecting other devices to this product, refer to the manual for the product to be connected. The black cable is ground, make sure to connect the ground wire first. Ensure that the ground cable is properly connected to metal parts of the vehicles body frame or direct to the battery if your vehicle does not have a grounded chassis frame. The ground cable of this units power amp and a second powered system must be connected to the frame separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire or malfunction. TROUBLESHOOTING GUIDE TROUBLE Unit will not turn on No sound is heard Cannot pair Bluetooth The audio quality is poor after connection with a Bluetooth enabled device Unit has become unresponsive CAUSE The fuse is blown SOLUTION Check / replace the fuse Ignition not engaged Turn ignition to on position Blown speaker Replace faulty speaker Volume is low / muted Press the volume level up Device is paused or muted Check your devices playing / volume status The Bluetooth function of the device is not enabled Refer to the user manual of the device for how to enable the Bluetooth function The MGR450B BT memory is full Follow how to reconnect a device in section E The Bluetooth reception is poor Move the device closer to the audio system or remove any obstacle between the device and the systems antenna Power glitch or interference Disconnect power for 10 seconds to reset Low battery power Charge battery, run the engine to recharge the battery Reset the main system Follow steps in section B TECHNICAL SUPPORT 1-805-751-4853 www.bossaudio.com/support 2 SUGGESTED MOUNTING METHODS 3 WIRE DIAGRAM CAUTION!! Using other mounting methods may void this warranty TOOLS NEEDED: - Measuring Tape / Ruler - Wrench and/or Pliers - Hole Saw - Crimp Tool FOR CHARGING ONLY: Cell Phone and iPod Media Playback Not Supported CAUTION!! Do not ground or short the speaker leads SPECIFICATIONS FM TUNER FREQUENCY RANGE • USA 87.5~107.9MHz • Europe 87.5~108MHz • Asia 87.5~108MHz • Australia 87.5~108MHz • Usable Sensitivity: 12dB (S/N=30dB) • Bands: 2 AM TUNER FREQUENCY RANGE • USA 530~1710KHz • Europe 522~1620KHz • Asia 522~1620KHz • Australia 522~1620KHz • Usable Sensitivity: 40dB (S/N=20dB) • Bands: 1 INTEGRATED AMPLIFIER • MOSFET • MAX Continuous Output: 240W (All channels driven) • PEAK Power Rating: 60W / channel • Channels: 4 • Class: AB • Frequency Response: 20-20kHz • 4Ω stable CHASSIS • Button Backlight Illumination: BLUE LED • F/R/S RCA Preamp Output: 2VRMS • RCA Input Impedance: 10kΩ • LCD: TN Type / Active Matrix WEATHER BAND SELECTION • CH.1 162.400MHz • CH.2 162.425MHz • CH.3 162.450MHz • CH.4 162.475MHz • CH.5 162.500MHz • CH.6 162.525MHz • CH.7 162.550MHz • Bands: 1 BLUETOOTH • BT: 3.0 • BT Range: 33Ft / 10M (Class 2) • BT Profiles: A2DP / AVRCP 1.3 USB DRIVE MEDIA SUPPORTED • MP3 • WMA • 65,000 Songs • 32GB / FAT 32 • USB 2.0 High Speed • USB Output Voltage: 5VDC @ 1A GENERAL • Power Source: 14.4VDC (10.8V ~ 16V allowable) • Grounding System: Negative type • Maximum Current Consumption: 15A • 3-way protection circuitry (thermal, overload, and speaker short protection) • Unit Weight: 1.08lbs / 0.52kg • Storage Temperature: -22oF to 176oF / -30oC to 80oC • Operation Temperature: -4oF to 158oF / -20oC to 70oC • Replacement Fuse: 15A (Replace with AGU Fuse Type Only) Specifications subject to change without notice QUICK START GUIDE