Brother International ADS-1200 Quick Setup Guide - Page 8

Product Safety Guide Federal Communications Commission (FCC) supplier's Declaration of Conformity (For USA Only) Responsible Party: Brother International Corporation 200 Crossing Boulevard Bridgewater, NJ 08807-0911 USA TEL: (908) 704-1700 declares, that the products Product Name: ADS-1190, ADS-1200, ADS-1250W and ADS‑1700W complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: „„ Reorient or relocate the receiving antenna. „„ Increase the separation between the equipment and receiver. „„ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. „„ Consult the dealer or an experienced radio/TV technician for help. (ADS-1250W, ADS-1700W only) „„ This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. IMPORTANT • Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user's authority to operate the equipment. • A specific shielded interface cable should be used to ensure compliance with the limits for a Class B digital device. 8 Industry Canada Compliance Statement (Canada only) This device complies with Industry Canada's licenceexempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement. For use in the USA or Canada only These machines are made for use in the USA and Canada only. We cannot recommend using them overseas because the power requirements of your machine may not be compatible with the power available in foreign countries. Using USA or Canada models overseas is at your own risk and may void your warranty. International ENERGY STAR® Qualification Statement The purpose of the International ENERGY STAR® Program is to promote the development and popularization of energy-efficient equipment. As an ENERGY STAR® Partner, Brother Industries, Ltd. has determined that this product meets the ENERGY STAR® specifications for energy efficiency.