Brother International ADS-2200 Quick Setup Guide - Page 8

Product Safety Guide Federal Communications Commission (FCC) Declaration of Conformity (USA only) Responsible Party: Brother International Corporation 200 Crossing Boulevard Bridgewater, NJ 08807-0911 USA TEL: (908) 704-1700 declares, that the products Product Name: ADS-2200 and ADS-2700W comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: „„ Reorient or relocate the receiving antenna. „„ Increase the separation between the equipment and receiver. „„ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. „„ Consult the dealer or an experienced, qualified computer service. (ADS-2700W only) „„ This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. IMPORTANT • Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user's authority to operate the equipment. • A specific shielded interface cable should be used to ensure compliance with the limits for a Class B digital device. 8 For use in the USA only These machines are made for use in the USA only. We cannot recommend using them overseas because the power requirements of your machine may not be compatible with the power available in foreign countries. Using USA models overseas is at your own risk and may void your warranty. LAN connection (ADS-2700W only) IMPORTANT DO NOT connect this product to a LAN connection that is subject to over-voltages. International ENERGY STAR® Qualification Statement The purpose of the International ENERGY STAR® Program is to promote the development and popularization of energy-efficient equipment. As an ENERGY STAR® Partner, Brother Industries, Ltd. has determined that this product meets the ENERGY STAR® specifications for energy efficiency. RF Exposure Notice (USA only) (ADS-2700W only) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20 cm or more away from person's body.