Brother International BE-1206B Tubular to Cap - English - Page 1

BE-1204, 1206 For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: [email protected] Website: http://www.brother-usa.com/industembroidery/tech_down.aspx With the power to the machine OFF. 1. Remove the tubular attachment. This will vary depending on your machine model. BE-1204B/BE1206B - Loosen the pair of black thumbscrews on the pantograph that hold on each the tubular arms. Slide the thumbscrews toward the center of the tubular arms and them remove the arms. BE-1204C - Remove the pair of black thumbscrews on the pantograph that hold on each the tubular arm and remove each tubular attachment. 2. Remove the two black thumbscrews from the cap frame assembly. Then slide the cap driver onto the machine. Each cap assembley is labeled as to what head it goes on. 3. Lift up on the cap frame sash so that the positioning pins fit into the oval holes and lower on to the pantograph. 4. Hold the fixed lever as shown and insert in to the hole underneath the pantograph. Push up and toward the inside until it stops. Then lock the fixed lever by pushing down. Do this to the other side. Positioning Pin 3/10/05 1