Brother International BM3850 Users Manual - English and Spanish - Page 44
lightly pull on the thread while slowly
View all Brother International BM3850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
USING ATTACHMENTS AND APPLICATIONS Position the fabric (wrong side facing up) 4 under the presser foot. Lower the needle 3 mm (1/8 inch) from the edges of the fabric, lower the presser foot, and then sew 2 or 3 stitches. 1 After sewing 2 (3/4 inch) to 3 cm (1 1/8 8 inch) of the fabric, release the thread and guide the fabric from the front of the presser foot with your both hands. Keep a uniform amount of fabric wrapped around the presser foot curl until the seam is completed. 2 2 1 Needle 2 3 mm (1/8 inch) Raise the needle and the presser foot, then 5 hold the ends of the upper and lower thread to prevent them from being pulled out of the fabric and pull the fabric out from the front of the presser foot. ■ If too little fabric is wrapped around the curl, then a threefold seam is not being sewn Holding both threads, pass them through 6 the curled part of the presser foot and pull them toward the back of the presser foot. Wrap the fabric around the curled part of the presser foot in the same way. Position the edge of the fabric just behind the needle and lower the presser foot. Pull the fabric held in your right hand to the left in order to increase the amount of fabric wrapped in the presser foot curl. At the same time, carefully guide the fabric to the right with your left hand. ■ If too much fabric is wrapped around the curl, then a wide threefold seam is being sewn Without allowing the fabric to stick out 7 from the right side of the presser foot, lightly pull on the thread while slowly sewing. Pull the fabric held in your right hand to the right in order to decrease the amount of fabric wrapped in the presser foot curl. At the same time, carefully guide the extra fabric to the left with your left hand. 43