Brother International CP60X Operation Manual - Page 30
Error Messages
View all Brother International CP60X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Symptom, Cause/solution Reference The sewing light bulb does not come on. The sewing light is damaged. * The fabric feeds in the opposite direction. The feed mechanism is damaged. * The needle contacts the needle plate. The needle clamp screw is loose. 13 The needle is turned, bent or the point is dull. 13 Fabric being sewn with the machine cannot be removed. Thread is tangled below the needle plate. 27 A broken needle has fallen into the machine. XX Turn off the machine, and remove the needle plate. If the needle that fell into the machine can be seen, use tweezers to remove it. After removing the needle, return the needle plate to its original position and insert a new needle. Before turning on the machine, slowly turn the handwheel toward you to check that it turns smoothly and that the 24 new needle enters through the center of the needle plate opening. If the handwheel does not turn smoothly or the needle that fell into the machine cannot be removed, consult your authorized Brother dealer or the nearest Brother authorized service center. The handwheel does not turn smoothly. Thread is tangled in the bobbin case. 27 Decorative stitch patterns are misaligned. ★ A wrong presser foot is used. 14 Stitch adjustment is set incorrectly. 23 Error Messages No. Cause Solution The foot controller was pressed (or ("Start/Stop" button) was pressed if the foot Lower the presser controller is not connected ★) foot lever before or (Reverse/Reinforcement continuing the stitch button) was pressed operation. while the presser foot is raised. A stitch other than the buttonhole or bar tack stitch was selected and the foot controller was pressed (or ("Start/Stop" button) was pressed if the foot controller is not connected ★) while the Raise the buttonhole lever before continuing the operation. buttonhole lever is lowered. The buttonhole or bar tack stitch was selected and the Lower the foot controller was pressed (or buttonhole ("Start/Stop" button) was lever before pressed if the foot controller continuing the is not connected ★) while the operation. buttonhole lever is raised. 30 No. Cause Solution (Reverse/Reinforcement stitch button) (or (Needle position button) ★) was pressed while the bobbin winder shaft is moved to the right. Move the bobbin winder shaft to the left before continuing the operation. ("Start/Stop" button) was pressed while the foot controller is connected. ★ Disconnect the foot controller or use the foot controller. ★ Remove The motor locked up because the thread is tangled. the tangled thread before continuing the operation. The stitch only for the single needle was selected and the foot controller was pressed (or ("Start/Stop" button) was pressed if the foot controller Select a stitch for the twin needle. is not connected ★) while the twin needle mode is active. The machine may be malfunctioning. Contact your nearest Brother authorized service center. Operation beep ★ • When the machine is turned on or a key is pressed (correct operation) XXOne beep • When the machine is turned on while a setting is changed (page 6) XXTwo beeps • If an incorrect operation is performed or a nonfunctioning key is pressed XXTwo or four beeps • If the machine locks up, for example, because the thread is tangled XX Beeps for four seconds and the machine automatically stops. Be sure to check for the cause of the error, and correct it before continuing to sew. ★: Only for some models.