Brother International Innov-is PS500 Operation Manual - Page 21
Winding/Installing the Bobbin
View all Brother International Innov-is PS500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Winding/Installing the Bobbin CAUTION • Only use the Bobbin (part code: SA156, SFB: XA5539-151) designed specifically for this machine. Use of any other bobbin may result in injuries or damage to the machine. • The included bobbin was designed specifically for this machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB: XA5539-151). SA156 is Class15 type bobbin. Winding/Installing the Bobbin Memo • The shape of the bobbin winder guide post will differ depending on your model; however, this should not affect the operating procedure. This manual describes the procedure for models with a key-shaped bobbin winder guide post. B 1 GETTING READY 1 Bobbin winder guide post (oval) 1 * Made of plastic 1 This model 2 Other models 3 11.5 mm (approx. 7/16 inch) Memo • When the foot controller is connected, bobbin winding can be started and stopped with the foot controller. Winding the bobbin This section describes how to wind thread onto a bobbin. 1 Bobbin winder guide post (key) Open the top cover. a Place the bobbin on the bobbin winder shaft so that the b spring on the shaft fits into the notch in the bobbin. Press down on the bobbin until it snaps into place. 1 2 1 Notch 2 Bobbin winder shaft spring Slide the bobbin winder in the direction of the arrow c until it snaps into place. • The "Start/Stop" button lights up in orange. Basic operations B-13